File Display Border
These options affect the File Display border - the caption or
title bar that is displayed above the file displays in the Lister.
- Allow docking of Listers: When this is enabled, you can
drag one single display Lister over the title bar of another to dock them
together (the Lister you dragged is closed, the Lister you docked it with is
changed to dual display mode, and the folder tabs it was showing are opened in
the new display). You can also split a dual display Lister into two single
displays by dragging from the file display border.
- Enable file display Copy and Swap border buttons: Enables
additional buttons in the border that let you copy one file display to another
(puts the Lister into dual mode if it isn't already), or swap the
position of the two file displays (when already in dual mode).
- Enable hot paths in file display border: When this is
turned on, you can click individual path segments in the border to browse to
the current folder's parent locations.
- Only when file display is the source and the Lister is
active: Applies to the above option - path segments are only "hot" in
the source display. This lets you click the destination display to switch
source / destination without accidentally clicking a path segment.
- Set file display to source when Up/Back/Forwards buttons are
used: If turned off, the source/destination state of the file display
will be unaffected when these buttons are used to navigate.
- Show file display border in single display mode: The
borders have to be displayed in dual mode (to indicate which side is the source and which is the
destination), but you can turn it off in single display mode to save
space.